this device must accept any interference received, including interference that may cause undesired operation.this device may not cause harmful interference, and.Operation is subject to the following two conditions: This device complies with part 15 of the FCC Rules and the Product Specifications noted on the Declaration of Conformity. This Equipment is intended for rack mount use only. If connected to 240V supply, a suitable CSA/UL certified power cord shall be used for this supply. For rack-mount or installation where plug is not accessible, an all-pole mains switch with a contact separation of at least 3 mm in each pole shall be incorporated into the electrical installation of the rack or building. MAINS DISCONNECT: The plug shall remain readily operable. POWER ON/OFF SWITCH: The Power switch used in this piece of equipment DOES NOT break the connection from the mains.
Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Refer all servicing to qualified service personnel. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Use only with the cart stand, tripod bracket, or table specified by the manufacture, or sold with the apparatus. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. If the provided plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet. The wide blade or third prong are provided for your safety. A grounding type plug has two blades and a third grounding prong. A polarized plug has two blades with one wider than the other. UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.ĭo not defeat the safety purpose of the polarized or grounding-type plug. ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.
INSTALL IN ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS.ĭO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. The apparatus shall not be exposed to dripping or splashing liquid and no object filled with liquid, such as vases, shall be placed on the apparatus.ĭO NOT BLOCK ANY OF THE VENTILATION OPENINGS. WARNING FOR YOUR PROTECTION READ THE FOLLOWING:
Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).įor Countries not mentioned above, please contact your local authorities for a correct method of disposal.īy doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. If you want to dispose this product, do not mix it with general household waste. Replacement fuses are 13 amps and MUST be ASTA approved to BS1362. Replacement fuse covers can be obtained from your local retailer. NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET.ĭo not use the mains plug without the fuse cover in place. Discard the mains plug at a suitable disposal facility. The following is indicative of low altitude use do not use this product above 2000m.Ī molded mains plug that has been cut off from the cord is unsafe.
Disconnect the unit during storms to prevent damage. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. Opening the chassis for any reason will void the manufacturer’s warranty. Refer all servicing to qualified personnel. Do not attempt to service the unit yourself. These symbols warn that there are no user serviceable parts inside the unit. The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner’s manual. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products.
Full Range Application 3 (All Outputs Full Range).Full Range Application 2 (Sub-Satellite System).Parametric EQ (AutoEQ, HIGH, MID, LOW PEQ).The PA2 Processing Modules & Parameters.
Driver Alignment Delay, Polarity, & Crossover Filter Types